J2534 Vxdiag Nano online Service Programming System
Buick 2008 GL8 Firstland Service Programming System (SPS) with J2534 Vxdiag
Confirmed:
J2534 Vxdiag Nano can perform online Service Programming System (SPS) on many GM /Opel car models, like Buick 2008 Passenger car GL8 Firstland (C) 3.0L V6 LZC. This article is available with the whole procedure.
Car info:
Buick 2008
Passenger car
GL8 Firstland
(C) 3.0L V6 LZC
Controller:
ECM: Engine Control Module – Programming (Pass -Thru Only)
TCM: Transmission Control Module
PSDM: Power Sliding Door Module – Programming
CCP: Climate Control Panel – programming
Purpose: Reprogram (Normal not VCI)
Using:
Login ACDelco for subscription of Service Programming System (SPS)
Procedure:
Login ACDelco TDS.
Click on “Service and Programming Information”.
Choose ” Service Programming Only” and click on “Access your subscription”.
Click on “OK”.
Click on “Service Programming System (SPS)”.
Click on “Start SPS” and it will automatically launch Java 6.
Skip software installation of Tech2 J2534 Driver.
Select “J2534 VXDIAG” – “Reprogram ECU“, then “Next“.
Read messages “Connect J2534 device to vehicle and PC”.
Select Buick car info.
Confirm car VIN.
Select ” ECM: Engine Control Module – Programming (Pass -Thru Only)”, then “Normal”.
Configuration succeed.
Click on “Next” and then “OK” to reprogram with the same calibration.
Transfer data.
1). Download from server
2). Load to ECU.
It may take a long time to finish, please ensure the computer not sleep.
3). Programming complete.
Click on “New”, then “Next”, select ” TCM: Transmission Control Module”, then “Normal”.
Read the reprogramming instruction.
Download from the server completed.
Done.
