ECU programmer:
Purpose:
read bosch Me7.01
Symptom:
When i press read, Data led starts blinking and ECU/ON and KEY/ON led light up.
Then ECU/ON and KEY/ON leds goes of and Data led stops blinking and only have a solid light.
And software stops at this point: 0%.
I got 2pcs cable: 14P600KT02
Non of the cables works on the ktag box but when testing cables on my KessV2 box they work with K-Line and i can read the ME7.01 ecu.
When i messure K-Line voltage i get diffrent voltage depending on the PSU voltage i power ktag box with.
Included 12V Power supply -> K-Line voltage 10V
LAB PSU 13.2V -> K-Line voltage 12V
LAB PSU 24V -> K-Line voltage 22V
This is my pcb
How to solve this problem?
Nothing wrong. All is good. Choose correct protocol as K-suite suggests.
Change out that 8.0mhz resonator. Cheap one. Get Murata CStNE8M00GH5L000R0
Remove the old 8.00m chip and put this part number on the smaller 3 pad below the original.
Ktag Red PCB China clone tech support: obdexpress.co.uk
